Revision as of 22:14, 3 June 2015

Hardware

HackRF

1MHz - 6GHz, RX/TX half-duplex, BW 20MHz, ADC/DAC 8bit
https://github.com/mossmann/hackrf/wiki
Bias-T supply can deliver 3.3V 50mA
BW & filtering: https://github.com/mossmann/hackrf/wiki/Tips-and-Tricks
FW flashing

$ hackrf_info
Found HackRF board.
Board ID Number: 2 (HackRF One)
Firmware Version: 2014.08.1
Part ID Number: 0xa000cb3c 0x0067434c
Serial Number: 0x00000000 0x00000000 0x15d463dc 0x383f8125

Airspy

24MHz - 1.750GHz, RX, BW 10MHz (9MHz alias free), ADC 12bit (10.4 ENOB)
Bias-T supply can deliver 4.5V
FW flashing

$ airspy_info

Found AirSpy board 1
Board ID Number: 0 (AIRSPY)
Firmware Version: AirSpy NOS v1.0.0-rc5-0-g648c14f 2015-05-20
Part ID Number: 0x6906002B 0x00000030
Serial Number: 0x618C63C82F7424A7
Supported sample rates:
	10.000000 MSPS
	2.500000 MSPS
Close board 1

RTL-SDR

~25MHz - 2GHz, RX, BW 2.4-2.8MHz, ADC 8bit
Mine: 52-2212 MHz with gap @ 1107-1241 MHz

LNA: Low Noise Amplifiers

LNA4ALL
- 28-2500MHz, gain about 22dB from 28MHz to 600MHz then gain drops to ~16dB @ 1400MHz and ~11dB @ 2500MHz, 0.75dB NF @ 1 GHz and 0.98dB NF @ 2 GHz
- 6-9 V, 55-65 mA (5V if regulator bridged)
- can be powered by HackRF or Airspy if modified, 10uH SMD on OUT and regulator bridged (because we deliver <5V) or bridged by 100mA fuse, just in case.
LNA4HF
- 150kHz - 30MHz, gain 18-20 dB, NF 1-2 dB
- 6-9 V, 18 mA (5V if regulator bridged)
- up to 2GHz if low-pass filter removed
Better to position LNA near antenna than near receiver, more useful info here